ClubSport Table Clamp V2 vs V1 ?

[scoddee]

How are they different ?

Scotty

 

[Mr Latte]

Id like to get one from Thomas to review and compare it to the V1 I have.

So far I have only seen a diagram as of yet.
I believe it has two adjustable clamps now and not one.
Not sure if any other differences in finish but requires the CSRE to be attached to its own angled stand first.

 

[LogiForce]

Id like to get one from Thomas to review and compare it to the V1 I have.

So far I have only seen a diagram as of yet.
I believe it has two adjustable clamps now and not one.
Not sure if any other differences in finish but requires the CSRE to be attached to its own angled stand first.

If that's the case jonboy did an unboxing of a V2 on his YouTube channel.

 

[Mr Latte]

Well you have been paying attention havnt you

 

[LogiForce]

Well you have been paying attention havnt you

I feel I have to be as a CSW tester. How can I inform people properly if I don't know what is going on in the world of sim hard and software?

Still I am not sure if I'll be able to live up to everyone's expectations when the time comes but I will be doing my best. Until that time comes I'll use my knowledge to help and inform.

 

[Crispy]

It has two adjustable screws now for extra stability. This thing is rock solid, and it's even been causing my rig to sway during FFB. (Although that may be the Elite) I plan on writing a review on that after the Elite, as well as a review on the CSR Shifters.

 

[scoddee]

Thanks guys.👍 Here's Logi's link http://www.youtube.com/watch?v=EY6_FM0iwZc&feature=related It does seem to be a nice improvement.

Scotty

 

[LogiForce]

Thanks guys.👍 Here's Logi's link http://www.youtube.com/watch?v=EY6_FM0iwZc&feature=related It does seem to be a nice improvement.

Scotty

Thanks Scotty. I didn't have the time to post it earlier but let's embed that in here for easy viewing.