Hi
I got a good deal on a dfgt and could possibly have Thrustmaster 458 wheels today.
I read a post here where someone successfully rewired the dfgt cable to TM pedals.
I tried to restructure the original instructions although not sure what lowest point of the cervo means.
The user also states to take photo's of original wiring outside the pedal set so people can just join the cables. Does that mean the same colored wires are used for both vendors and some solder and heat shrink is all that is needed?
______________________________________________________________________________________
Tools:
Instructions :
Make a second red and black wire
Throttle:
I got a good deal on a dfgt and could possibly have Thrustmaster 458 wheels today.
I read a post here where someone successfully rewired the dfgt cable to TM pedals.
I tried to restructure the original instructions although not sure what lowest point of the cervo means.
The user also states to take photo's of original wiring outside the pedal set so people can just join the cables. Does that mean the same colored wires are used for both vendors and some solder and heat shrink is all that is needed?
______________________________________________________________________________________
Tools:
- 1 small philips screwdriver
- 1 wire stripper
- industrial tape or heatshrink
- soldering iron
Instructions :
Make a second red and black wire
Throttle:
- Solder the 2 red wires directly to the lowest of the 3 points of the cervo.
- Solder the white wire to the middle point on the cervo of your throttle.
- Make a second black wire and connect them both to the upper solder point of the cervo.
- The secondary red and black wire are inverted from the throttle-pedal on the brake servo
- Solder the green wire to the center of the Brake
- Reinstall the back plate
