Okay so I got the Forza and G27 combo thinking it was an easy peasy setup. I am still struggling to do it even after heavily researching on youtube and amazon (looking for, but lost the manual for the G27, which I can't find online on Logitech's website)
1) I can't mount the pedals to the plate that came with the Motorsport 3 playseat. The screwholes don't align. I tried both with the support that comes with the playseat pedal plate and without it. Either way the screws don't align and there's nothing to stop the pedals from moving to the left and right when I'm using it
2) The gear shift holder..... ugh I thought this would be an easy fit too. Unfortunately the mounting screw on the gearshift for the G27 won't fit into the gearshift holder. The only thing I could think of is to take this off, but the screwhole for two screwholes to remove the mount are very very narrow and deep (especially compared to an online video I saw of the G25). I will try to get a mini screw driver set at target tommorow that fits this.
Anyone have any guidance for either of these problems? Especially #1 since I might have to simply disassemble the shift holder to get it to mount for #2
1) I can't mount the pedals to the plate that came with the Motorsport 3 playseat. The screwholes don't align. I tried both with the support that comes with the playseat pedal plate and without it. Either way the screws don't align and there's nothing to stop the pedals from moving to the left and right when I'm using it
2) The gear shift holder..... ugh I thought this would be an easy fit too. Unfortunately the mounting screw on the gearshift for the G27 won't fit into the gearshift holder. The only thing I could think of is to take this off, but the screwhole for two screwholes to remove the mount are very very narrow and deep (especially compared to an online video I saw of the G25). I will try to get a mini screw driver set at target tommorow that fits this.
Anyone have any guidance for either of these problems? Especially #1 since I might have to simply disassemble the shift holder to get it to mount for #2
