Handbrake wiring for csp pedals v3

[BlackChevelle]

Hi,

I was wondering if anybody here would know what is the wiring pattern in the csp pedals v3 board.

Of course I looked for past topics on it and found this thread:
https://www.gtplanet.net/forum/threads/clubsport-and-csr-elite-pedals-handbrake-diy-info.280445/

The thing is Csp v3 pedals now use a rj12 female plug instead of a 4 pin european one... i guess it still use 3 pin only but I would like to know which ones are used.

Somebody here knows? I wish MrBasher could help me out, but it seems that he didn't show up since a little while...

Thanks!

 

[BlackChevelle]

Just found it myself. If somebody needs it somewhen...

Pins that are used are Pin 4, Pin 2 and pin 6. Then just connect it to a 3.5mm jack like the real cable or directly to your analog sensor like in the link of my previous comment.

If any question, just ask.

 

[zeroasdf]

4- Positive 3.3v
2 - Signal into the board
3 - Ground
Is it this way? My English is not very good, I don’t know if you can understand me, thank you