NASCAR Daytona and Indy long run setup help

  • Thread starter rockstar95
  • 6 comments
  • 2,540 views
37
rockstar95_86
Title says it all. My current setup for Indy will let me run 20 laps or so when I race with others. In long races at Indy, I try to stay with the pack, but not race with everyone and conserve my tires. Like I said, I can only last about 20 laps, at the absolute most, maybe a few more if I have to, no matter what I do. I notice early on in the race that the LR tire doesn't wear very much. My right sides seem to wear off first. What is causing this and what can I do to fix it? As the tires wear the car gets tight and if I drive it in too deep, it jus pushes like a dump truck.

It depends at Daytona how long I can last depending on how hard I race everyone and how smooth I am with the wheel. I can go 25-28 laps and no further. It jus becomes too loose to drive. I am using a wheel. Thanks for your help!!!:)
 
Posting your setup would help you get advice, it's difficult for anyone to guess what's wrong with it off your description alone.
 
My Indy setup. I'm running Jeff Gordon's car.
Ride Height- 12 front and rear
Spring- 13.4 F and 13.9 R
Extension- 1 F and 3 R
Comp-2 F and 4 R
Roll bar- 6 F&R
Camber -2.0 F 0.5 R
Toe -0.10 F and none in the rear
Ballast Amount 10 Ballast Position 45
Aero 50 F and 60 R

My Daytona setup. Running Dale Jr.
Ride Height- 12 front and rear
Spring- 15.8 F and 14.3 R
Extension-5 F and 6 R
Comp- 6 F and 7 R
Roll bars- 6 Front and rear
Camber- 2.0 F and 0.5 R
Toe Angle -0.10 F and none in the rear.
Ballast amount 10 Position 45
Aero- 43 F and 48 R

Help is greatly needed and appreciated!
 
Back