- 1
- Uruguay
Hi guys!
I don't have electronic knowledge so i need help and some tips!!
I have 2 AURA Bass Shakers (50w 4ohms conected to a lepy 4x45w amp , but turns off after a while) and i will buy another 2 AURA to use with sim vibe.
The idea is to work in Front and Back independently , So, i will need 2 amps... I did some research and after all i think the best solution is to buy 2 amp boards, maybe 2 of these :
https://www.parts-express.com/sure-...-amplifier-board-(t-amp-technology)--320-3340
with this power supply.
https://www.parts-express.com/mean-...MTg5&newReg=y&turntoflowConfDupe=y#turntodone
Do you think is a good setup ?? What about this power supply ?or is to much and i have a cheaper option?
Will i need something else to run? or with all this stuff is ok?
Also, How do you raise and lower the volume? (I'm worried about frying the bass shakers)
I'm from Uruguay so should be 220v/50hz.
Another idea i have is to use my JBL car Amp
http://demandware.edgesuite.net/aau...5.1593094498.1505075057-1654397309.1505075057
Will this work? or not?
This is the spec:
Audio Specifications
Signal-to-Noise Ratio93dB
Total Peak Power Output435W
THD + N<1%
Frequency Response20Hz-20kHz
Input Sensitivity20mV-20V
Bridged Power Output170W x 2 into 4 ohms
4-Ohm Power Output60 Watts RMS x 4 channels
Variable Bass Boost0 to + 12dB @45Hz
2-Ohm Power Output85 Watts RMS x 4 channels
Thank you all for the time and help!!!!!!!!!!!
I don't have electronic knowledge so i need help and some tips!!
I have 2 AURA Bass Shakers (50w 4ohms conected to a lepy 4x45w amp , but turns off after a while) and i will buy another 2 AURA to use with sim vibe.
The idea is to work in Front and Back independently , So, i will need 2 amps... I did some research and after all i think the best solution is to buy 2 amp boards, maybe 2 of these :
https://www.parts-express.com/sure-...-amplifier-board-(t-amp-technology)--320-3340
with this power supply.
https://www.parts-express.com/mean-...MTg5&newReg=y&turntoflowConfDupe=y#turntodone
Do you think is a good setup ?? What about this power supply ?or is to much and i have a cheaper option?
Will i need something else to run? or with all this stuff is ok?
Also, How do you raise and lower the volume? (I'm worried about frying the bass shakers)
I'm from Uruguay so should be 220v/50hz.
Another idea i have is to use my JBL car Amp
http://demandware.edgesuite.net/aau...5.1593094498.1505075057-1654397309.1505075057
Will this work? or not?
This is the spec:
Audio Specifications
Signal-to-Noise Ratio93dB
Total Peak Power Output435W
THD + N<1%
Frequency Response20Hz-20kHz
Input Sensitivity20mV-20V
Bridged Power Output170W x 2 into 4 ohms
4-Ohm Power Output60 Watts RMS x 4 channels
Variable Bass Boost0 to + 12dB @45Hz
2-Ohm Power Output85 Watts RMS x 4 channels
Thank you all for the time and help!!!!!!!!!!!
