? about VR3 and buttkicker

[ForNgoods]

I'm planning on getting the vision racer VR3 soon and was wondering how i was gonna physically attach my Buttkicker gamer to the rig? From the pics i've seen, there doesnt seem to be any place around the seat area that would make for a good mounting location. Is there anyone out there with this setup that has found a good location for the vibration mechanism?? Thanks in advance.

 

[gslooney]

It really needs a bar strapped across under the seat mounting points. however there are two holes on the seat frames on either side at the back..
So I just got an old socket, a couple of washers, a nut and bolt out and did this!!

it actually works well. But I'd rather it was under the seat..

 

[ForNgoods]

Is there not enough space underneath the seat to place a bar across the two mounting holes? anyways thanks for the response. I'll have to figure something out but your solution might be the way to go. thanks again.

 

[gslooney]

There is enough space, I just haven't done it yet