T-lcm accelerator sticking at 100%

Thank you for your comments. I’ve had the issue recur twice since 6 May post, so not frequent but annoying.

I’ve now found that unplugging the pedal base, closing down, waiting, restarting, then replugging the base solves the issue. This has worked the twice the problem has occurred. I’m hopeful this will keep working, if it happens again.

Now the issue is why is it happening in the first place? Seems like a software glitch but I can’t prove that.

I also suffer from the same heavy foot issue as you, no idea what causes that.

Good luck with getting a replacement cable
 
I got the cable now. I am pleased it actually works as I took a risk getting it. Just need to see if it prevents the glitch with the pedals.
What is needed cable wise is-

DEC MMJ to DEC MMJ 2m 6PIN DATA CABLE - Straight Wired - Pin to Pin​


What thrustmaster describes it as was not much use.
 
Ok, the cable is new, and I got 100% stuck throttle today. So its something else. Still think it has to do with earthing/voltage glitches with the pedal itself. Will take it apart again and clean/allign the metal contacts to the pedal.
 
アクセルの静電気エラー問題は、
埃を掃除した後、
TRUSCOの静電気除去シートを敷いて、
その上にペダル+ハンコンのフレームを置く事で解決しました。

真冬にエアコン暖房付けて乾燥していても、
アクセルペダルの静電気エラーが起きなくなったので、
日本は電力インフラ世界一なので、電力不足や漏電も少ない為、日本のコンセントの仕様上、接地アースなど難しい場合はお勧めです。
 
Back