T598 Firmware Update Problem

[pjgoeman]

I’m trying to update the firmware on my new T598. I’ve followed all the steps for downloading the Thrustmaster panel, Microsoft software, etc. The TM Panel recognizes my T598, serial number, etc. I followed the instructions on pressing the buttons to initiate the firmware update, the panel on the device went out as it’s supposed to, and I have a message on my laptop screen that says “Checking if your device is in boot mode” and the little circle thing goes round and round forever.

The first time this happened I x’d out of everything and started over with a 2nd attempt but got the same results.

Any ideas?

Thanks

 

[WildRun]

If the firmware update not works, then try this:

1) Turn On your T598 base and on the main page, click on the button FIRMWARE RECOVERY

2) Click on OPEN FIRMWARE UPDATER

3) Set your wheelbase on the Boot Mode (= turn Off the base, press simultaneously L3 + SETTINGS buttons, keep pressing and turn ON during this time the base)

4) Select V2.07 on Firmware tab, and click on OK to launch the firmware update

 

[pjgoeman]

Your suggestion worked. Thank you very much from a very non-tech savvy user!