TOCA 3 Shootouts III - DTM @ Oschersleben Motorpark - Result is up!

  • Thread starter Prince.M5
  • 35 comments
  • 5,245 views
I was managing around 1:04.8x without tuning. I just happened to floor it though the corners and I did get lucky when cornering around the 2nd corner.
 
I always had problems at turn 5 and 6 because of the bumpiness of the kerbs... Means that I always ran wide for turn 6... I believe I lost a lot of time there. Nonetheless, I already did my best for this competition ;)
 
I remember on the first turn, there was one small bump that had me rev up. Got me annoyed because I couldn't counter the rev, or loss of grip :irked:. And that tight chicane around the 35 sec mark. Tried flooring it - I spun out. Braking - I went to slow. Coasting through it - still too slow. So I had to let off the throttle for a millisecond and then floor it. Cutting as much as possible without getting penalised:lol:
 
Yeah I think I know that tight chicane that you're talking about, around turn 4 that led to a small hairpin right? If so then yes, I had a little problem at that corner too... But anyway, you just cut as deep as you can through that corner. Because if you follow the tarmac, then surely you'll lose approx. 0.3-0.5 seconds assuming. Furthermore, you will just ran wide through that chicane. God I hate that section that then follows the bumpy kerbs of turn 5 and 6 :lol:
 
Um, no. Looking on the map, I'm talking about Shell Kurve and Ammann Kurve. I hate the curbs there - that's my 'make or break' turn.
 
Um, no. Looking on the map, I'm talking about Shell Kurve and Ammann Kurve. I hate the curbs there - that's my 'make or break' turn.

Owh, my mistake :lol:

Well i don't seem to have much of a problem there... This track is quite a challenge still.

Anyways, I'm going to host a new one later ;)👍
 
Back