Troble getting the RX7 Infini setting right!

[BERZERK]

help i cant get the settings of the RX7 Infini right could it be i went to far with weight stage 3?

is there a way to set it up for this weight to drift well?

 

[LanEvo]

lighter cars are easier to drift..less weight pushing the tires against the road. with a stage 3 weight reduction...only other modifcations would be maybe a racing exhaust and sim tires. then ya drift it.

 

[Leetheslacker]

I dunno why by the FC's seem to be a bit funky to setup sometimes...

 

[bengee]

i find that a stage three fc needs a reaction time to correct drifts that most beginning drifters do not have... there is a limit to lightweight... as there is a limit to any other kind of tuning... if you want to throttle steer you need weight for weight transfer and stuff... so to some extent weight it good... and too light a car on too stiff a spring constant is bad for drifting... but good for sliding...

 

[Thio]

For beginner drifters, it may be hard to drift light cars because there's not much weight to shift around. In my opinion, the beginner drifters should try drifting cars stock so they know how to transfer weight and then start doing the weight reduction. By then, their reaction is prone to fixing drifts much faster than in the beginning when they start drifting.

Since you have a Stage Three Weight Reduction, I suppose you just have to be patient with the way the car reacts. Drift it slowly with oversteer and keep on increasing the speed as you finish complete laps. Patience is the key word here

 

[Ryosuke_Gumna]

try the setting of Cudaman......the king of the drifting!............

 

[TingBoy]

i never liked drifting with stage 3 weight reduction...but that's just me ^_^

 

[battle_stage]

All you need is a lowered suspension and sims in my opinion. Work fine for me...