If anyone is interested, this is my tune for the Miura 👍.
Miura
500pp, 301bhp, 911kg.
No oil, No wing, No Rigidity improvement.
90/90
5.00/5.23
3/3
3/3
7/7
0/0
-0.10/0
Racing brakes 5/3
Trans:
Initial FG: 3100
Max speed 124mph (min)
1: 4499
2: 3153
3: 2585
4: 2120
5: 1774
FG: 2500
LSD: 10/8/5. triple clutch.
Power 86.4%. All standard parts.
Stage 1 weight reduction.
Hope it helps!
Since I had Cr.50,000,000 I thought I might as well buy this Cr.15,000,000 Miura everyone is raving about. Hah! Seems to have a mis-valued PP which lets it have a lot of power at this weight.
Thanks to
@SW__10 recently posted
tune for Miura Bertone Prototype, this DS3 novice just did
1:06.921 currently
175th in the world!
Controls
Active Steering: Off
TCS: 2 [triggers have huge dead zone either side of a tiny 'active' area on my DS3]
ASM: Off
ABS: 1
Steering Sensitivity: 5
Stats
500pp
282bhp
871kg
45:55
37kgfm
Suspension
Fully Customised
90 90
5.00 5.23
3 3
3 3
7 7
-0.20 0.05
Race Brakes
7 4 [looks strange but balances perfectly with other settings]
Drivetrain
Fully Customisable
10 7 5
Triple Clutch Kit
Power
80.9%
Standard parts
[Did oil change by mistake which means a lot of limiter which drops the torque curve at high revs.
Don't do oil change!]
Transmission
Set power first, I think.
Final: 4.995 [to get round numbers]
Max. Speed: 200km/h [full left]
1: 2.550 [use through first 2 hairpins only]
2: 1.950 [hold through next 2 hairpins, exiting onto short bridge]
3: 1.550 [hold through the long banked right before the road goes uphill into the tunnel, also hold through final double-apex right]
4: 1.250 [change down for fast sweeping right after bridge - don't go to road edge on exit!]
5: 1.000 [slightly wider gears might remove the need to use 5th, possibly faster?]
Final: 4.000
Body
Wheels: 1 "Inch Up" [don't think it matters which?]
Custom Rear Wing from GT Auto shop [don't think it matters which?]
Downforce: 0 20 [0 is locked]
Ballast Weight: 9kg
Ballast Position: 10%
Weight Reduction: Stage 3
Experience
My highest final place was 210th using the 600pp ZZII around Tsukuba a month or two ago. (I don't remember any other results so assume that was the best.)
I struggle to control the throttle with DS3 triggers...and to drive generally! So I went for a
lighter and less powerful set of parts. I had some ballast leftover from
@praiano63 tune
in his tuning garage and using different stages of weight reduction. [Edit: Toe is from his tune, too!]
Ballast position was 50% originally. Was this a typo on the tune sheet? Tried -50% for a while and it provided stability but cost some lap time. Changed some other things randomly. The final position was from making it central, then moving 10% at a time. 20% was too extreme for me.