Fanatec ClubSport and CSR Elite wheel owners Motor Mod Poll

[eKretz]

Begs the question, how reliable and fast wil guy #2 be?
Just wondering as it might be faster grabbing my own from some place and basically try my luck sticking to the specs you gave earlier. Which were...

- 24 VDC
- 2.5A stall current
- 4200 rpm no load revolutions

Though what's the Fana-Buchi can diameter, width and maybe screw hole distance?

You have the specs right so far, and the other relevant specs for the stock motors are as follows:

Can diameter: 38mm (1.496")
(Actually flux ring dia, but the heat sinks mount to that)
Can length: 57mm (2.245")
Motor Pilot Dia: 13mm (.512")
Motor Shaft Dia: .125" (3.175mm)
Mount screws: 3mm x .5mm pitch
Screw center dist: 25mm (.984")

Thanks for the encouragement guys, still no word from the first guy. Should be able to get in touch with the 2nd one in the next few days.

 

[BiG_DawG_81]

You have the specs right so far, and the other relevant specs for the stock motors are as follows:

Can diameter: 38mm (1.496")
(Actually flux ring dia, but the heat sinks mount to that)
Can length: 57mm (2.245")
Motor Pilot Dia: 13mm (.512")
Motor Shaft Dia: .125" (3.175mm)
Mount screws: 3mm x .5mm pitch
Screw center dist: 25mm (.984")

Thanks for the encouragement guys, still no word from the first guy. Should be able to get in touch with the 2nd one in the next few days.

Hey eKretz how's it going. I've just seen this thread and am quite interested. As I'm an aircon mechanic I am capable of replacing the motors with either option 1 or option 2.

I'm quite interested to hear where you are at with this endeavor so if you could let us all know that would be great.

 

[eKretz]

Page 1 of the CSW/CSR Elite modder's thread has all the info you are looking for.