Downforce: 60/85
Transmission: 261mph
LSD Initial: 10
LSD Accel: 20
LSD Brake: 20
Ride Height: -30/-30
Spring Rate: 16.0/12.0
Dampers Extention: 1/1
Dampers Compression: 1/1
Anti-Roll: 6/6
Camber Angle: 2.0/1.8
Toe Angle: -0.20/0.20
Brake Balance: 5/6
Those are the Mazda 787B settings that Roj gave me.
So i went for a spin on La Sarthe with the rotary powered beast!
I was used to driving with racing line on but now im trying to learn the tracks and basically enjoy the tracks while getting the feel of cars through each corner, its much funner driving this way than following the racing line.
Before the new tune, the 787B is very twitchy and tends to understeer quite a bit. I could never nail the 3rd Chicane on the straight and the last two chicanes of La Sarthe. I just keep going wide and going too slow to prevent going wide. The time then was about 3.24.XX.
With new settings, i can overcome the understeer and twitch while exiting corners. It felt like driving a whole new car, its very stable through corners, wheel slip and braking times are minimised. Yes, on the 2nd gear, you do have to be cautious with the throttle depending on the situation at that moment. You dont want to over power the throttle while turning with 2nd gear unless you want to end up with the car facing backwards. I got a consistent 3.20.XX after about 3 laps of adjusting to driving on La Sarthe without driving line. I could improve on the times easily as my braking points were all over the place but the car delivers, it does what you want to do.
Obligatory pic of Mazda 787B exiting the turn 'Arnage' on La Sarthe: