- 632
- The Netherlands
Is is it possible to remove the top of a car with a soft top?
For example, could you drive the Mazda MX-5 open?
For example, could you drive the Mazda MX-5 open?
Chassis Swap List
- Thread starter anthaliscious
- 1,538 comments
- 401,103 views
- 3,662
- NRW - Aachen
- MCR-Eddy
If somebody would find the code and put the california code in the MX5 it would be possible
- 632
- The Netherlands
- 632
- The Netherlands
Anyone found a chassis that fits the Prius? 
- 2,790
- Greece
Chaparral 2D Race car chassis
Dodge Challenger SRT8 TC chassis
CodeRedR51
Premium
- 55,318
- United States
ZedMan1996
(Banned)
- 2,597
- South East
- ZedMan1996
- 342
- raptorspy
Mitsubishi HSR-II Concept '89 with an Audi R8 '01 race car chassis swap
Last edited:
Dan
Premium
- 15,396
- United States
Perhaps the Chaparral 2D? I don't know. The only Ferrari I ever owned were the 458 (which I got rid of immediately) and an Enzo. Maybe one of the new Ferrari's have a chassis for it like a California.
- 342
- raptorspy
Land Rover Range Stormer Concept '04 with a XJR-9 chassis swap. A little narrow I'd say but perfect fit otherwise.
Toyota Supra 3.0GT Turbo A '88 with a Wedssport Celica chassis swap
ZedMan1996
(Banned)
- 2,597
- South East
- ZedMan1996
Anybody got a decent chassis for the FIAT 500F '68? I need some "poke" on that thing.
Dan
Premium
- 15,396
- United States
X1... wait that's been done.
How about... no. Or...? No.
What are you putting on it that needs more "poke"??? Did you see my thread about the V12 Fiat 500?
CodeRedR51
Premium
- 55,318
- United States
Anyone find anything for the RX-8 yet that doesn't require crazy camber?
- 706
- South Dakota
- Fat_Buff_Guy
I tried the 1200 bug today on the RUF RGT Chassis and didn't think it fit very well at all. Length wise it fits well, but not width wise, its far to wide.
I have put the MK1 GTI on the Lotus Elise 111R Chassis though and I think it works awesome.
I had to raise it a bit from this because the back wheels didn't quit look right. But over all its pretty slick.
Trial Mountain Circuit by GT5NUT, on Flickr
I have put the MK1 GTI on the Lotus Elise 111R Chassis though and I think it works awesome.
I had to raise it a bit from this because the back wheels didn't quit look right. But over all its pretty slick.
Trial Mountain Circuit by GT5NUT, on Flickr
- 1,289
- Salt Lake City
- Ferraridude308
Mazda Atenza Touring Car. I'm currently using the suspension from the RX-8 race car, and it goes nicely with the Atenza chassis. I don't know the camber values on it because I just made this car about an hour ago. Much nicer than stock, without stupid amounts camber to get it to fit.
Last edited:
CodeRedR51
Premium
- 55,318
- United States
Awesome, thanks man. I was just going to do some work on the car so I'll do that now. It's also getting the Furai 3-Rotor. 
- 1,289
- Salt Lake City
- Ferraridude308
I've been playing with this car for a couple weeks now, I think I've finally got a winning combination chassis-wise.
Lotus Esprit V8 :: RE-Amemiya GT300 RX-7 '06 Chassis
I'm quite surprised at how well this chassis fits, the stock one leaves a lot to be desired, but this one looks great and fits the car amazingly. (.5 Front Camber : 0 Rear)
I'm quite surprised at how well this chassis fits, the stock one leaves a lot to be desired, but this one looks great and fits the car amazingly. (.5 Front Camber : 0 Rear)
CodeRedR51
Premium
- 55,318
- United States
- 2,993
- Brisbane
- jimipitbull
try the GTR Concept LM chassis
- 632
- The Netherlands
Did anyone else notice that if you slam a car the tires will go a little bit into the ground?
Not all the cars have this, but a few I tried had this problem...
Am I doing anything wrong?
Not all the cars have this, but a few I tried had this problem...
Am I doing anything wrong?
- 2,529
- Alton, Illinois
- big_noobowski924
- 632
- The Netherlands
- 6,515
- Sydney
- Stavingo
Yes we've all seen it dude, a bit off topic this is the home of flush cars and sweet rides not bad news
Similar threads
