Fanatec Gran Turismo DD Extreme Wheel

[Oi Oi JC]

Anyways this is what my CSL Elite V2 pedals are doing now when hooked up to GT DD Extreme in GT7.
I guess load cell is failing, it's falling out of calibration, but also there's an invisible phantom glitch every few seconds that resets the upper brake deadzone limit when in calibration screen in GT7. I wonder if anyone else has that glitch where it resets the upper calibration. Might be pedals, might be FW/ wheel.. not sure. 🤷‍♂️

This may or may not be news to you, but when in calibration mode, if you hold the brake pressure at a certain point for something like 3 or 4 seconds the pedals will set that as the new maximum (100%) pressure point.
That may be why your upper dead zone keeps changing?

 

[Kriptical]

@xDriver69x

Fair enough.

This is the ddX in game 10/8
100/100/100
ndp 29.
The rest, zero.

Compared to prepatch this is actually quite decent. Prior to this the oscillations were stronger and occupied a wider radius. As long as the wheel is turning it behaves. Its only on the straights once the vehicle is moving fast that it decides to get squirrelly. Im of the mind that this is created by road textures coming in without (enough) dampening and as previously stated, I haven’t even plugged the base into a pc, let alone change anything. So kinda thinking this is PD. But hey, firmware for fanatec has been a wild ride this year. Maybe its both of them.

Fortunately, since Thursday, gr3 and below are pretty good. Gr1 and the prototypes however are still a bit annoying.