GT7 & PSVR2

[jenson86]

Yes; the key is both of them have to be on the same network.

My PS5 is connected to the router via LAN cable and my phone is connected to WiFi. When I performed the initial scan, it picked up my PS5 quickly. Afterwards, each time I start the app I see my PS5 already there.

ok thanks. Strange it doesn't work for me. I have a switch in between router and PS5 and a guest wifi network. Maybe one of these two causes the problem?

 

[GBO Possum]

ok thanks. Strange it doesn't work for me. I have a switch in between router and PS5 and a guest wifi network. Maybe one of these two causes the problem?

If you are using the Guest Network, it may isolate wireless devices from wired devices.

If your router has “AP Isolation” (Wireless Isolation) enabled, it could block communication between WiFi and wired devices.

PS I'm no expert, so I asked ChatGPT's "Technical Advisor". Trust but verify!! 😂

 

[Revengel]

PS I'm no expert, so I asked ChatGPT's "Technical Advisor". Trust but verify!! 😂

The part of me that remembers Nixon doubled over with laughter!!!

 

[JohnnyMac]

Can the headset and Pulse Elites fit on your ears? Thought we would be limited only to ear buds? Im sure i tried headphones before and they didnt sit right.

I wear the Pulse Elite under the PSVR2, works fine. I also have the Globular Cluster mod kit installed and having no problems. It takes a little bit to get it all adjusted to fit right; main thing is to thread whichever top strap you are using from the GC kit in between the two top arcs on the Elites. 👍

 

[TheNormsk]

OK, this is a dumb question.

To get 3-D sound on my headphones I have to plug them into the controller. If I plug them into the VR2 headset, I only get a stereo. When plug into the controller and flatscreen the sound for the game is routed to the headphones and it goes quiet on the TV, which is what I want. But, if I put the VR2 headset on then the sound remains on the TV and also goes through the headphones.

Is there a way in the settings so that when using the headphones in VR all the sound also goes to the headphones and not the TV.?

My wife complains the TV is too loud so when I’m in VR, I would like it to be quiet. Simple enough eh?

 

[Jump_Ace]

Hmmm, first option would be to press Mute on the TV remote. Otherwise, I'd say check both the GT7 audio settings and PS4/5 audio settings to see if there's an option to always route sound to a headset when its detected.


Jerome

 

[TheNormsk]

Hmmm, first option would be to press Mute on the TV remote. Otherwise, I'd say check both the GT7 audio settings and PS4/5 audio settings to see if there's an option to always route sound to a headset when its detected.


Jerome

Yep mute is the easiest way. 😁.

Was just hoping there was a setting. Having found it yet.

 

[PapaLegba]

Yep mute is the easiest way. 😁.

Was just hoping there was a setting. Having found it yet.

There is a toggle switch in the PS5 sound/audio settings to “Switch sound output automatically” that should do this.
I’m the opposite and only want avr sound at all times. Sometimes it’s either the game or VR headset which thinks I’m using headphones even though none are plugged in anywhere, resulting in no sound at all. Turns out thats more of a proper order and timing of powering on the headset issue- I learned from trial and error- but I found that toggle while troubleshooting. I keep it toggled off, but having it toggled on may solve your issue.
System Settings- Sound- Sound Output (headphones)- Switch sound output automatically.