My cars
https://www.gtplanet.net/forum/showpost.php?p=3756173&postcount=466
Ok I'm not too good at explaining things but here we go.
I started on 1 side the rear is a scewed square (yellow) next a scewed square (orange) then another scewed square in your body colour to get the width you want your orange.
On the roof.
Use a square and enlarge it so it reaches left side to right line this up with orange then do the other side then yellow and so on now both sides are finished.
Now that square on the roof make it fill the rear half of the roof(yellow)
put a stretched square down over the bonnet and roof (orange) (if not long enough put another over it)
repeat this with the center stripe (yellow)
(1) now the final stage scew a circle (orange) so it meets the join of orange + yellow on side and roof when happy with that move it into the center of the roof and add another scewed circle over it to ensure there the same size the position them to the orange + yellow joints each side.
Follow (1) again but this time you will be using the body colour to finish the orange on the roof.
Really hope this makes sense. I'm sure if you look at the pic after reading this you'll work it out.
nice work by the way did you know the EVO9 kills the 10 though?
