- 564
- Barcelona
- Metentso
Yes those are good points, maybe I will cover the opening with tape to prevent dust, although it's narrow and in vertical, but better safe than sorry.Id caution you with using oil in this case. It will attract dust and eventually gum up the microswitch underneath, if the oil doesn’t end up in the microswitch causing a complete failure. #warrantydenial. Also keep in mind that there is a circuit board under there, and being part of a steering wheel that gets turned in every direction as well as vibrations from trueforce. The oil will spread out over time.
For the qr click, if you can isolate it to the qr, a drop of oil may help, if away from any circuitry or entry points. I may try that if it came up with mine. But i think in your case hawkeyez has the right idea, though will cost more than you’d want and likely difficult to locate. Just my 2c, good luck, happy racing
About the oil spreading, not much I can do now, just pray. I didn't apply much of it but it's a spray so difficult to control. Didn't think about turning the wheel so the excess oil would go to the side, that would've been a good trick. Ah well let's hope for the best.
edit: Maybe I will leave the wheel upside down so the oil would go the the harmless center and top. Eventually it will thin out and stay there hopefully
With qr you mean the quick release?
Last edited: